Kisho Glass Coating Value Kit Si-901 Manual

- Jan 30, 2018-


Designation of product: kisho glass coating value kit Si-901


1. 8 Si-901 glass coating agents (30ml);

2. 8 Glass coating sponges;

3. 1 Manual.

Product features:

Si-901 glass coating agent is top-level kisho glass coating product, featured with various glass coating advantages for top performance. Combined practice with X-03 protectant after practice, can protect the coating film in its hardening stage, and also can effectively prevent raindrop imprint, enabling perfect glass coating effectiveness.


Pre-practice treatment

Finish treatment before vehicle glass coating is dependent on finish conditions, and it is critical to the practice, for inferior treatment may influence the adhesiveness and basic performance of glass coating film, thus please determine whether it needs iron powder removal, grinding and polishing, and air gun blow-off procedures on basis of the finish conditions, but do note that degreasing is necessary.

Precautions before the practice

1. This product is fast try, please avoid practice under burning sun, otherwise wiping would be impeded;

2. Avoid practice in temperature environment under 10;

3. Please carry out practice under complete cool-off state of the vehicle body, since vehicle body heat may expedite product hardening rate leading to wiping obstruction;

4. Please completely clear fouling attached on vehicle body and carry out degreasing before practice;

5. Please read practice manual in details and follow practice procedures therein.

Si-901 glass coating agent practice method

1. Before smearing glass coating, spray a thin layer of moisture on the glass coating area evenly (upon smearing moisture does not drop being benchmark);

2. Drip Si-901 glass coating agent to glass coating sponge for 4-6 drops, first swear it laterally, then swear it vertically with "#" pattern, recommended at 50cm*50cm for each practice area;

3. Wait 1-6 minutes to wipe after smearing, first use a wet towel to wipe with even strength (no need to wipe repeatedly, just spread the glass coating agent), then immediately use a dry towel to wipe the glass coating layer, until the surface is bright and smooth. Wiping duration recommendation: 30=within 2 min, 20=within 4 min, 10=within 6 min, glass coating hardening rate is directly correlated with temperature and humidity, thus it is recommended to measure local temperature and humidity before determining the wiping duration;

4. Check wiping omission for each part under completion, until the whole vehicle is covered.

5. Single practice of glass coating effectiveness is well enough, nevertheless the second practice will increase thickness and durability of coating film, in this case please exercise the second practice after previous one no sooner than 1-2 hours, or combined with practice of Si-701 premium glass coating overlay.

6. Upon completion of practice, perform subsequent practice according to X-03 protectant practice procedures.


1. Do not smear the whole vehicle by one time, to avoid difficulty of post-hardening treatment, please carry out practice part by part;

2. While wiping dry, observe the surface in well lighted location, to avoid remaining residue, and if indoor illumination is inferior, drive the vehicle outdoor to conduct inspection and wiping in full range, to ensure perfect practice quality;

3. After practice, complete hardening of the coating film requires around 1 week, thus do not engage water or rinse the vehicle before complete hardening;

4. This product is a mild irritant to human body, please wear protective gloves if allergic with its practice.

Storage method

1. Sealed storage in shade, optimal for 4-10(avoid high temperature and freezing);

2. Please store out of the range within children touch.


· Do not drink; · Do not engage fireworks; · Wash hands with soap after using;

· Immediately consult doctors for misguided intake and eye contact; · Do not use for purposes other than vehicle practice.