Car paint surface ceramic coating needs to determine the products used and the car ceramic coating process according to the degree of use of the car. Generally, we divide cars into new cars, sub-new cars and old cars. The use procedures of various levels of vehicles are different. The following is mainly for everyone to explain Let's take a look at the KISHO automotive ceramic coating process of automotive paint finish.
First, the entire car will be washed to remove the dirt on the surface of the car paint and prepare for the subsequent use of ceramic coating. The whole process takes about 20-40 minutes.
Step 2: After cleaning the car body, remove the sludge and carefully remove the stains on the paint surface, guano, gum, asphalt, cement and other stains.
The third step: degreasing treatment, in order to remove the residual wax grease left on the car surface during polishing, if the paint surface is not degreasing treatment, there will be wax grease residue on the car paint surface, and the crystals will cause ceramic coating as the car is cleaned The layer falls off, which directly affects the durability of the ceramic coating effect.
The ceramic coating of the new car only needs to be degreasing treatment. Because the paint surface of a new car has no attachments, dirt, and scratches, it is very simple to use ceramic coating for a new car.
Sub-new cars and old cars:
Step 4: Perform ceramic coating
Use Si-701 ceramic coating, Postpone for 2-8 minutes after smearing, then use a dry towel to clear surface residue whilst wiping the glass coating film with polishing brightness. Wiping duration recommendation: 30℃=within 3 min, 20℃=within 5 min, 10℃=within 8 min, glass coating hardening rate is directly correlated with temperature and humidity, thus it is recommended to measure local temperature and humidity before determining the wiping duration;
Use Si-901 ceramic coating, After completion of whole vehicle Si-701 glass coating practice, postpone for above 1-2 hours to carry out Si-901 practice, enabling enhanced effective given by an initial hardening process of Si-701 coating film;
Before smearing glass coating, spray a thin layer of moisture on the glass coating area evenly
. Wait 1-6 minutes to wipe after smearing, first use a wet towel to wipe with even strength (no need to wipe repeatedly, just spread the glass coating agent), then immediately use a dry towel to wipe the glass coating layer, until the surface is bright and smooth. Wiping duration recommendation: 30℃=within 2 min, 20℃=within 4 min, 10℃=within 6 min, glass coating hardening rate is directly correlated with temperature and humidity, thus it is recommended to measure local temperature and humidity before determining the wiping duration;
Use Top24,Spray TOP-24 on a clean and cool paint surface, spray it in an area of 30cm*30cm, and wipe it evenly with a dry towel.
After using ceramic coating to maintain the paint surface, the car paint will be as bright as new, the brightness will increase, the hardness will also increase, and it will feel smooth and smooth. Protect the paint for a long time and make it easier to take care of later.