Precautions before the practice
Instructions for use
1.Drip Si-811 glass coating agent to coating sponge for 7-10 drops, first swear it laterally, then swear it vertically with "#" pattern, recommended at 50cm*50cm for each practice area, and note the usage quantity, since excessive usage per time may lead to non-uniform smearing or wiping obstruction;
2.Wait 2-8 minutes to wipe after smearing, first use a wet towel to wipe with even strength (no need to wipe repeatedly, just spread the glass coating agent), then immediately use a dry towel to wipe the glass coating layer, until the surface is bright and smooth. Wiping duration recommendation: 30℃=within 3 min, 20℃=within 5 min, 10℃=within 8 min, glass coating hardening rate is directly correlated with temperature and humidity, thus it is recommended to measure local temperature and humidity before determining the wiping duration;
3.Check wiping omission for each part under completion, until the whole vehicle is covered.
4.Single practice of glass coating effectiveness is well enough, nevertheless the second practice will increase thickness and durability of coating film, in this case please exercise the second practice after previous one no sooner than 1-2 hours.
5.Upon completion of practice, perform subsequent practice according to X-03 maintain agent practice procedures.
Note
1. Do not smear the whole vehicle by one time, to avoid difficulty of post-hardening treatment, please carry out practice part by part;
2. While wiping dry, observe the surface in well lighted location, to avoid remaining residue, and if indoor illumination is inferior, drive the vehicle outdoor to conduct inspection and wiping in full range, to ensure perfect practice quality;
3. After practice, complete hardening of the coating film requires around 1 week, thus do not engage water or rinse the vehicle before complete hardening;