Everyone is well-known that the car paint must be thoroughly cleaned before waxing. In fact, the car paint is the same when using nano coating. Deep cleaning of the car paint will help the nano coating fluid to be more clean. It can penetrate into the paint surface and bring out the performance effect of nano coating more perfectly. The deep cleaning before nano coating mainly includes removing asphalt, removing iron powder, removing sludge and removing oxide layer, etc. If it is an old car, polishing the paint surface and scratches, and finally degreasing.
【Si-701 use steps】
1. Degreasing the paint surface after car washing: spray degreasing agent on the car wash sponge, scrub all parts of the car body, and fully rinse with clean water (if there is residue, it will affect the coating effect of the crystal plating. Avoid washing after the degreasing agent is dry).
2. Smearing and wiping link: wet the nano coating sponge with a small amount of water and then drip 7-10 drops of nano coating liquid (about half the amount of the door), and apply it in a uniform straight line, alternating horizontally and vertically. Smear, after smearing a board, after 3-7 minutes of drying time, brighten it with a dry towel to finish the nano coating application. Larger sections such as the roof and engine hood can be divided into 4 to 6 sections. From the second board surface, the sponge does not need to be sprayed with water. Please pay attention to the amount of nano coating solution.
3. Finish the use: After the vehicle is used as a whole, it needs to be carefully checked with light or sunlight. If you find any missing points, please wipe it again with a wet towel and a dry towel until it is smooth and bright. If it still does not come out clean, please use a soft sponge dipped in a relatively fine abrasive (water-soluble abrasive is recommended) and wipe gently.
The toughness and water repellency form an excellent weather-resistant film, which achieves amazing durability, antifouling and gloss.